+359 879 201 665 / +359 886 098 835
Home »Airsoft »Airsoft Parts »SWITCH ASSEMBLY, AK-47
Buy -BGN41.90
In stock:
Airsoft center
Manufacturer:Product #:
ULTIMATE® Upgrade Switch assembly.

For AK-47 with battery in stock.
All electric parts are made from a heat resisting compound.
All ULTIMATE® wires are produced in Japan, and are made of high-quality silver-wire, to ensure low resistance in ohm (?).
All electrical contact surfaces have a high-quality plating to ensure low inner resistance in ohm (?).

Any form of upgrade on an AEG places great demands on the electrical components. To get the most out of your upgrade we recommend changing the electric components at the same time. When making powerful upgrades, it is a must that you change the electrical components.
+ See more
Products from same category
Before using, read the manual. It is highly recommended that the ASCU be installed by an Airsoft technician with experience and knowledge on the subject. 
ASCU is an electrical module that dramatically improves the cycle of the gearbox (the mechanics of the replica). ASCU monitors the work of your Gearbox at all times - no matter how you pull the trigger, the replica will function in the same way. ASCU also have low battery protection. If the battery starts to drain, the electronics will give you a signal and stop the power supply. You can use Li-Po batteries from 7.4 to 12V, as well as NiMh and NiCd batteries. It is strongly recommended to use 11.1 or 12 V Li-Po batteries. If you want to use 7.4 Li-Po or 8.4 NiMh make sure that you install M90 or M100 spring. The ASCU will also stop the power supply in case of a problem in the gearbox. This way you will save the replica. No modifications or alterations to the gearbox are required to install the electronics. In a small number of cases, the gearbox may need to shed some small details so you can put the electronics safely. ASCU electronics work perfectly with quality motors like those from Ultimate line. In the kit you will find two-piece ASCU, cables and connector (cables and connectors are already installed in the electronics), a selector plate, a cut off lever and spring for the cut off and guide. In some cases, you have to use the factory selector plate which you have on the replica. ASCU Gen 5 can be reprogramming in different shooting modes. If you want to learn how to do this, read the instruction manual.

If you would like to contact an Airsoft technician for further questions on the subject, please click